Lay-Up Maintenance

Petrol and Glow engines. Problems and solutions.
Mike E
Posts: 26
Joined: Wed Aug 05, 2015 10:31 am

Lay-Up Maintenance

Postby Mike E » Thu Nov 19, 2015 7:54 pm

I have a couple of models that I haven't flown for a while.
In particular my 1/4 scale Piper Cub.

Engine. Saito 180
After removing the Glow plug and rotating the prop a few times I realised that the bearings sounded rather dry.
I added after run run oil (anti corrosive) into the plug opening and rotated the prop a couple of times.
I also sucked oil into the rear vent tube by rotating prop anticlockwise (otherwise it blows back).
This should lubricate the bearings.

Fuel Tank.
After removing the fuel tank I had a hell of a job removing the rubber bung.
The bung had deteriorated and found its own shape.
There was also evidence of serious corrosion of the internal vent and feed tubes
(Dead Stick scenarios).
I coudn't locally source replacement rubber bungs but found these maintenance kits.
http://hobbyking.com/hobbyking/store/__ ... g_Kit.html
Ive ordered two kits for £5.49 including postage.
If they do do the job I'll be well pleased.

Bottom Line.
If you have ic models that haven't flown for a while they may need a bit of TLC. :)

RickTee
Posts: 49
Joined: Sun Aug 02, 2015 12:06 pm

Re: Lay-Up Maintenance

Postby RickTee » Fri Nov 20, 2015 10:46 am

That looks like a nice kit, ally nut, lid and tubing. :)


Return to “IC Flight”

Who is online

Users browsing this forum: No registered users and 1 guest